Methenolone Enanthate 100mg/ml steroid Solutionfirstname.lastname@example.org
Semi-made means that all you need to do is just sterilizing the solution, such as filtration with 0.22 micron pore filters, then they are ready for use.
Don’t hesitate to contact via
1. send mails to email@example.com
Methenolone enanthate 100 mg / Primobolan Depot 100 / Primobolone 100
Affective chemical: Methenolone enanthate
Solvents: benzyl alcohol & benzyl benzoate
Carrier: USP Grape Seed Oil
Recipe for how to make Methenolone Enanthate with oil @ 100 mg/mL for 100 mL
10 grams Methenolone Enanthate powder (7.5 mL)
2 mL BA (2%)
20 mL BB (20%)
Grape Seed Oil 70.5 ml
Primo 100 will not aromatize in the body, therefore estrogenic side effects such as bloat should not be a concern. Bodybuilders with reasonably low body fat will notice an increase in definition and lean muscle mass.s
Primo, as it is often called, is a very popular steroid amongst bodybuilders who are in the “cutting” phase of their training and dieting. This steroid is very mild in its nature and seems to work exceptionally well with calorie restricted diets.
Methenolone Enanthate causes a slow and gradual release from the site of injection.
With an enanthate ester is added to the steroid, methenolone causes a slow and gradual release from the site of injection. Its duration of activity would thus be quite similar to testosterone enanthate, with blood levels remaining markedly elevated for approximately two weeks. Methenolone itself is a long acting anabolic, with extremely low androgenic properties. On the same note the anabolic effect is also quite mild, its potency considered to be slightly less than nandrolone decanoate on a milligram for milligram basis. For this reason, Primobolan is most commonly used during cutting cycles when a mass increase is not the main objective. Some athletes do prefer to combine a mild anabolic like “Primo” with bulking drugs such as Dianabol, Oxymethelone 50 or testosterone however, presumably to lower the overall androgen dosage and minimize uncomfortable side effects. When choosing between Primobolan preparations, the injectable is preferred over the oral for ail applications, as it is much more cost effective.
To obtain a faster and more enhanced effect.
In addition, it is most popular for male bodybuilders to stack Methenolone acetate with other (generally stronger) steroids in order to obtain a faster and more enhanced effect. During a dieting or cutting phase, a non-aromatizing androgen like Fluoxymesterone or trenbolone can be added. The strong androgenic component should help to bring about an added density and hardness to the muscles. On the other hand (or in addition) we could add Winstrol, another mild anabolic steroid. The result of this combination should again be a notable increase of muscle mass and hardness, but in this case the gain should not be accompanied by greatly increased side effects. As mentioned earlier, Methenolone enanthate is also used effectively during bulking phases of training. The addition of testosterone, Dianabol or Oxymetholone 50 would prove quite effective for adding new muscle mass. Of course we would have to deal with estrogenic side effects, but in such cases Methenolone acetate should allow the user to take a much lower dosage of the more “toxic” drug and still receive acceptable results.
Methenolone enanthate for women users.
Women respond well to a dosage of 50-100mg per week, although (as stated above) the oral should usually be given preference. Additionally, some choose to include Stanozolol (50 mg per week) or Oxandrolone (7.5l0mg daily) and receive a greatly enhanced anabolic effect. Remember though, androgenic activity can be a concern and should be watched, particularly when more than one anabolic is used at a time. If stacking, it would be best to use a much lower starting dosage for each drug than if they were to be used alone. This is especially good advice if you are unfamiliar with the effect such a combination may have on you. A popular recommendation would also be to first experiment by stacking with oral Methenolone acetate, and later venture into the injectable if this is still necessary.
1、50 Ml for 200mg/ml
10 grams Primobolan E Powder (7.5ml)
1ml BA (2%)
7.5ml BB (15%)
17ml Grapeseed Oil
17ml Ethyl Oleate
2、40ml for 100mg/ml
4 grams Methenolone enanthate
29 ml Grapeseed Oil
2ml Benzyl Alcohol = 5%
6ml benzyl benzoate = 15%
3、25ml for 200mg/ml
5 grams Methenolone enanthate (3.75ml)
16.25 ml Grapeseed Oil
1.25ml benzyl alcohol = 5%
3.75ml benzyl benzoate = 15%
4、300ml for 75mg/ml
22.5 grams Methenolone enanthate(16.875ml)
223.125 ml Grapeseed Oil
15ml Benzyl Alcohol = 5%
45ml benzyl benzoate = 15%
5、250ml for 100mg/ml
25 grams Methenolone enanthate (18.75)
176.25 ml Grapeseed Oil
5ml benzyl alcohol = 2%
50ml benzyl benzoate = 20%
6、250ml for 200mg/ml
50 grams Methenolone enanthate (37.5ml)
157.5 ml Grapeseed Oil
5ml benzyl alcohol = 2%
50ml benzyl benzoate = 20%